Skip to main content
Skip table of contents

BufferUp

Overview

Buffers the input into larger block sizes. Non-overlapping

Discussion

This module is the interface between small block processing and large block processing. The module buffers up small blocks of data into larger non-overlapping blocks. The larger blocks are executed in a lower priority thread compared to the smaller blocks. The module works on any 32-bit data type including integer, fract32, and floating-point.

The module is similar to the rebuffer_module.m. The rebuffer_module buffers up into OVERLAPPING blocks while this module buffers up into NONOVERLAPPING blocks.

The argument OUTBLOCKSIZE determines the blockSize of the output pin. If OUTBLOCKSIZE is positive, then the output blockSize equals OUTBLOCKSIZE. If OUTBLOCKSIZE is negative, then the output blockSize equals the input blockSize times (-OUTBLOCKSIZE).

Note, not all targets support this. Check the target documentation to see how many levels of audio processing are supported.

Type Definition

-Not Shown-

Pins

Input Pins

Name: in

Description: audio input

Data type: {float, int, fract32}

Channel range: Unrestricted

Block size range: Unrestricted

Sample rate range: Unrestricted

Complex support: Real and Complex

Output Pins

Name: out

Description: audio output

Data type: {float, int, fract32}

MATLAB Usage

File Name: buffer_up_subsystem.m

CODE
 SYS=buffer_up_subsystem(NAME, OUTBLOCKSIZE)
 Create a module which buffers up data into a larger block size.  The buffering
 is non-overlapping and the downstream processing occurs at a decimated block 
 rate.  Arguments:
    NAME - name of the module.
    OUTBLOCKSIZE - specifies the blockSize of the output pin.  If OUTBLOCKSIZE
       is positive, then the blockSize of the output pin equals OUTBLOCKSIZE.
       If OUTBLOCKSIZE is negative, then the blockSize of the output pin equals
       (-OUTBLOCKSIZE) times the blockSize of the input pin.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.